Trespa Pura NFC® Facade Panel - Slate Ebony - 3050 mm

• Simple and quick assembly.
• Horizontal and vertical processing.
• Concealed fastening with clip system and colour-matched screws.
Thanks to EBC technology:
• Closed and smooth surface minimises dirt.
• Heavy soiling such as graffiti or soot are easy to clean.
• High impact and scratch resistance.
• Rich colour tone even after decades.
• No painting or varnishing required.

Important: Substructure see description - not available in the shop!

The TRESPA® PURA NFC® façade panels beautify your façade with a premium solution in the form of natural fibre composite, a natural fibre composite in which layer pressings of wood fibres using a high-pressure process make the material extremely robust against extreme weather conditions. At the same time, the full gloss of the surface remains for decades without the need for tedious maintenance work.

• Diamond-like durability
In addition to impregnation with thermosetting resins and a decorative colour surface coating, the laminated panels are given a special transparent top layer, which is produced by: Electron Beam Curing -technology and thus improves weather and light protective properties. All components are bonded together with simultaneous application of heat (≥ 150 °C / ≥ 302° F) and high pressure (≥ 7 MPa), providing a non-porous material with increased density and integrated decorative surface.
• Environmentally friendly
The environmentally friendly NFC material consists of 70% wood fibres sourced from sustainable forestry and subject to PEFC™ certification.
• Ventilated system
Because the façade profiles are pre-hung on a substructure, a rear-ventilated system for water vapour dissipation is created.
• Simple installation
The façade panel can be installed vertically or horizontally. For the finish, e.g. on doors, windows on the sides or the corners, you can use the colour-matched façade profiles made of aluminium. These are easy to install and form a secure concealed transition to the façade panel.
The panels are cut to size without splintering the material - and no sealing of the cut edges is necessary!
• Easy maintenance
Thanks to the closed surface through the EBC technology, the accumulation of dirt is prevented. Impurities such as soot, graffiti or permanent markers can be easily removed. Painting or varnishing the façade panels is not necessary.
Your clip requirement:
• Clips: 10-15* pieces per square metre

*depending on construction method and local requirements

Substructure recommendation:
• Base batten - 40/60mm cross-section
  Insulation is placed between base battens
  
• Support batten - 30/50mm cross-section
  This is screwed parallel to the counter or base battens at a distance of 40cm from each other (as rear ventilation for façades/slabs/panels).